Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Air Supply
The recommended hook-up is shown in Figure A. Pneumatic tools
operate on a wide range of air pressures. For maximum efficiency
and longer tool life, the pressure of the air supplied to these
tools MusT not exceed the rated PSI at the tool when the tool is
running. Using a higher than rated pressure will cause faster wear
and drastically shorten the tool's life. A higher air pressure can also
cause an unsafe condition and explosion.
The inside diameter of the hose should be increased to
compensate for unusually long air hoses (over 25 feet).
Minimum hose diameter should be 3/8"
I.D. and fittings should have 1/4" NPT
thread.
The use of air line lubricators and air
line filters is recommended to prevent
water in the line that can damage the
tool. Drain the air tank daily. Clean the
air inlet filter screen on at least a weekly
schedule to remove accumulated dirt or
other matter that can restrict air flow.
The tool's air inlet used for connecting
an air supply has standard 1/4" NPT
American thread.
Safety Rules For Pneumatic Tools
1) Inspect the air hose for cracks or other problems.
2) Never point an air hose at another person.
3) Disconnect the tool when not in use, or before performing
4) Use proper hoses and fittings. Never use quick change
Figure A
Tool
Air Hose
Leader Hose
10
Replace the hose if worn.
service or changing accessories.
couplings attached to the tool. Instead, add a hose and
coupling between the tool and the air supply.
1/2"(or larger)
Pipe and Fittings
Coupler
Nipple
Oiler
Filter
Drain Daily
Publicité
