Operating Instructions; Turning Power On And Off - Hitachi PD1 42HDW10 Manuel Utilisateur

Table des Matières

Publicité

OPERATING INSTRUCTIONS

Turning Power On and Off

I To turn the monitor power ON, press the main power switch (
main unit to ON, and then press the SUB POWER button or the
the remote control.
I To turn the monitor power OFF, press the SUB POWER button or the
button on the remote control, and then press the main power switch ( ) on the
monitor main unit to OFF.
• During normal use, the main power switch (
can then be turned ON/OFF using the SUB POWER button or the
remote control.
Indicating lamp
Off
Lights red
Lights or blinks
green
• When the indicating lamp blinks in green or the message
"POWER SAVE" or "OUT OF FREQUENCY" appears on
the screen, there is something unusual about the status of
reception. See "Symptoms That Seemingly Appear to be
Failures."
23
TIPS
Power status
When the main power switch
Off
OFF.
When the main power switch (
and the
Off
remote control or the SUB POWER button
(standby)
on the underside of the front of the frame
is OFF.
When the main power switch (
and the
On
the SUB POWER button on the underside
of the front of the frame is ON.
• Avoid repeatedly turning the monitor on and off at short time
intervals. Failures might result from such operation.
• Turn off the main power switch (
of use for an extended period of time.
• If a power failure occurs while the main unit is running, it would be
powered on upon recovery from the failure. Turn off the unit main
power switch before leaving the main unit.
) is set in the ON position, and the monitor
Operating
button on the
button on the remote control or
SUB POWER
Main unit
) before leaving the monitor out
) on the monitor
or
button on
or
button on the
is set to
) is ON,
) is ON,
Main power
switch
Remote
controller
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières