Publicité
Les langues disponibles
Les langues disponibles
Assembly and operation
Assembly and operation of your TWO
are shown in the following drawing.
Please connect all components only when the mains power switch is switched OFF.
•
Place the speakers at their target area and start connecting.
•
First, connect the left speaker to the right speaker by the speaker cable. The gold-plated
binding posts can be turned and the stripped cable ends shall be fitted to connect red to red
and black to black. Turn the binding posts tight by hand, so that the cables can achieve a good
connection from the output of the right speaker (active) to the left speaker (passive).
Please care to avoid short circuits between red and black connectors, not to cause
malfunctions or defects!
•
Next, connect the input sockets LINE1 or LINE2 on the back of the right TWO
provided cable to an appropriate sound source.
The RCA (Cinch) sockets LINE1 L/R are prepared for audio sources with higher Line signal
level e.g. PC or stationary HiFi Components.
The 3.5mm phono socket LINE2 is prepared for audio sources with lower Line signal level e.g.
portable MP3-Players, Smartphones etc.
•
Turning the source selector switch on the left on the front of your TWO
between LINE1 (L1), LINE2 (L2) and Bluetooth (BT).
•
Before mains connections, check your mains power system to be appropriate to the TWO
The mains voltage (230V or 115V) of your power system you can set by the VOLTAGE
SELECTOR of your TWO
the mains voltage easily. Attention: if the mains voltage is set wrong, the device may become
defective! Always set the correct mains voltage to avoid defects!
•
Connect the mains cable to toe mains input socket and the Euro plug connect to your mains
supply.
English
speaker system is very easy to do. General connections
BT
(beside the POWER switch) and you can verify the actual setting of
BT
11
box via the
BT
, you can select
BT
BT
.
Publicité
