Publicité
Les langues disponibles
Les langues disponibles
1. Pull quick-connect coupler back and insert
nozzle.
2. Release quick-connect coupler and twist
nozzle to make sure it is secure in coupler.
WARNING: Flying object could cause risk
of serious injury. Ensure nozzle is completely
inserted in quick-connect socket and quick-
connect snap ring is fully engaged (forward)
before squeezing gun trigger.
Chemicals and Cleaning Solvents
Applying chemicals or cleaning solvents is a low-pressure operation.
note: Use only soaps and chemicals designed for pressure washer
use. Do not use bleach.
to aPPLY cHeMIcaLs anD soLVents
1. Press chemical hose (S) onto barbed fitting
located near high pressure hose connection
of pump as shown.
2. Place the other end of chemical hose with
filter on it into the container holding chemical/
cleaning solution.
note: For every 10 gallons (38 liters) of water
pumped 1 gallon (3.8 liters) of chemical/
cleaning solution will be used.
3. Install low-pressure (black) nozzle into quick connect fitting of spray
wand, refer to spray Wand nozzles. note: Chemicals and soaps
will not siphon if the black soap nozzle is not installed on the spray
wand.
4. After use of chemicals, place chemical hose into container of clean
water and draw clean water through chemical injection system to
rinse system thoroughly. If chemicals remain in the pump it could
be damaged. Pumps damaged due to chemicals will not be
covered under warranty.
Starting
WARNING: To reduce the risk of injury, read the pressure washer
instruction manual and the engine instruction manual before starting
pressure washer.
DANGER: Risk of fluid injection and laceration. When using the
high-pressure setting, DO NOT allow the high-pressure spray to come
in contact with unprotected skin, eyes, or with any pets or animals.
Serious injury will occur.
• Your washer operates at fluid pressures and velocities high
enough to penetrate human and animal flesh, which could result
in amputation or other serious injury. Leaks caused by loose fit-
tings or worn or damaged hoses can result in injection injuries.
DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a
physician immediately!
DANGER: Carbon Monoxide. Using an engine indoors can kill
you in minutes. Engine exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or smell. You
S
may be breathing CO even if you do not smell engine exhaust.
• Breathing ex h aust fumes will cause se r i o us injury or death!
En gine exhaust con tains carbon mon ox ide, an odorless and
deadly gas.
• Operate pressure washer in a well-ventilated area. Avoid
en closed areas such as ga rag es, base ments, etc.
• Never op e r a te unit in or near a lo c a t ion occupied by humans or
animals.
WARNING: Risk of fire, asphyxiation and burning. Never fill fuel tank
when engine is running or hot. Do not smoke when filling fuel tank.
• Never fill fuel tank completely. Fill tank to 1/2" (12.7 mm) below
bottom of filler neck to provide space for fuel expansion. Wipe
any fuel spillage from engine and equipment before starting
engine.
13
Publicité
