Télécharger Imprimer la page

DeWalt DXPW60606 Guide D'utilisation page 12

Laveuse à pression

Publicité

Les langues disponibles

Les langues disponibles

oPeration
Pressure Adjustments
The pressure setting is preset at the factory to achieve op ti mum pres-
sure and cleaning. To lower the pres sure, follow these instructions.
1. Back away from the sur face to be cleaned. The further away you
are, the less the pressure will be on the surface to be cleaned.
2. Change to the 40˚ nozzle (white). This nozzle delivers a less
powerful stream of water and a wider spray pattern. Refer to
spray Wand nozzles.
NOTICE: DO NOT attempt to increase pump pressure. A higher
pressure setting than the factory set pressure may damage pump.
3. Reduce the speed of the gasoline engine (RPM). Slow the engine
down and the water pressure will go down with it.
Spray Wand Nozzles (Fig. 1)
The nozzles for the spray wand are stored in the nozzle holder (B) on the
panel assembly (A). Colors on the panel identify nozzle location and spray
pattern. Refer to the following chart to choose the correct nozzle for
the job to be performed.
nozzle color
spray Pattern
red
15˚
Yellow
uses
surfaces*
powerful
metal or
pinpoint for very
concrete;
intense cleaning
DO NOT use on
wood
intense cleaning
metal, concrete
of small areas
or wood
nozzle color
spray Pattern
˚
25
Green
˚
40
White
low pressure
Black
* NOTICE: The high-pressure spray from your pressure washer
is capable of causing damage to surfaces such as wood, glass,
automobile paint, auto striping and trim, delicate objects such
as flowers and shrubs. Before spraying, check the item to
be cleaned to assure yourself that it is strong enough to resist
damage from the force of spray.
cHanGInG nozzLes on sPraY WanD
DANGER: Risk of fluid injection. Do not direct discharge stream
toward persons, unprotected skin, eyes or any pets or animals.
Serious injury will occur.
WARNING: Flying objects could cause risk of serious injury. DO
NOT attempt to change nozzles while pressure washer is running. Turn
engine off before changing nozzles.
12
uses
surfaces*
intense cleaning
metal, concrete
of larger areas
or wood
covers wide
metal, concrete,
areas of
wood or vinyl
cleaning
applies cleaning
metal, concrete,
solutions
wood or vinyl

Publicité

loading