Publicité
Les langues disponibles
Les langues disponibles
tools required (not included):
1/2" (13 mm) open-end wrench
1/2" (13 mm) socket or 1/2" (13 mm) wrench
Hardware (Included with your machine):
1 Handle (F)
1 Leg Assembly (DD)
4 Bolts (EE)
8 Flat Washers (FF)
4 Nuts (GG)
1. Remember to secure/support the machine before removing or
loosening the bolts. Use the wrench and socket to remove the leg
assembly bolts (EE, GG).
2. Position/slide the handle (O) into the frame (F) and on the outside
of each side of the foot bracket assembly (DD).
3. Align the holes in the Handle with the mounting holes in the frame
and leg assemblies.
4. Fasten the handle (O) to the foot bracket (DD) and frame (F) with
the hardware (EE, FF, GG) from step 1 as shown and tighten each
nut until snug.
FF
EE
FF EE
O
GG
F
FF
FF
GG
DD
5. Attach high-pressure
hose (P) to spray gun.
Make sure it is secure.
6. Connect wand (E) to
spray gun. Make sure
connection is secure.
7. Place the grommets
(B) onto the panel assembly (A) and push into place.
A
8. Remove the five colored quick-connect nozzles from the plastic bag
and insert them into correct grommet on the nozzle holder. Nozzles
are color coded to match colored nozzles on panel assembly.
note: The high-pressure pump was filled with oil at the factory.
Always check oil level before using (refer to Maintenance for more
information).
WARNING: Risk of bursting. Use a tire pressure gauge to check the
tires pressure before each use and while inflating tires; see the tire sidewall
for the correct tire pressure.
note: Air tanks, compressors and similar equipment used to inflate
tires can fill small tires similar to these very rapidly. Adjust pressure
regulator on air supply to no more than the rating of the tire pressure.
Add air in small increments and frequently use the tire gauge to
prevent over inflation.
9. The pressure washer is now ready for handling. Make sure to
follow the Owner's Manual instructions before starting the pressure
washer.
11
P
E
B
Publicité
