Working With The Agitator; Maintenance And Care; Storage; Guarantee - ATIKA RW 1800 Twin Notice Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
W
o
r
k
i
n
g
w
W
o
r
k
i
n
g
Instruction for using the agitator
Hold the device with both hands during mixing.
Do not reach in the running beaters (rotating beaters).
Avoid splashing. Work with low speed when immersing
the beater in the material to be mixed or pulling it out.
Only use beaters recommended by the manufacturer.
Pay attention the max. diameter:Ø 220 mm - RW 1800
Twin.
The supplied mortar beaters are suitable for materials with
tough and tenacious consistency: e.g. mortar, knifing fillers,
cement, plaster, lime, concrete, flooring plaster, etc.
Increase the speed during the mixing process. Immerse the
beater through the material to be mixed until it is thoroughly
mixed. Follow the processing instructions from the suppli-
ers.
Do not work with low speed in continuous mode. This
may result in overloading/overheating the motor as no suffi-
cient cooling can be generated.
M
a
i
n
t
M
a
i
n
t
Before each maintenance and cleaning
work:
- switch off device
- wait for standstill of the beater
- pull out power plug
Use only original parts. Other parts can result in unexpected
damages and injuries.
Maintenance and repair work beyond this is only allowed to be
carried out by the manufacturer or authorized service staff.
Store unused equipment in a dry, locked place out of the reach
of children.
Observe the following to maintain the operability of the
machine:
Keep vent slits clean and free from obstructions.
Remove dust and dirt using a cloth or a soft brush.
Do not clean the machine with running water or high-
pressure cleaners.
Do not use solvents for the synthetic parts (petrol, alcohol,
etc.) as these can damage the synthetic parts.
Check that the handles are properly secured.
Clean the beaters.
The agitator is equipped with carbon brushes. Have the
carbon brushes be replaced by the customer service if they
are worn
Regularly check the beaters for damages for your own
safety.
Always replace the beaters in pairs.
i
t
h
t
h
e
a
g
i
t
a
t
o
r
w
i
t
h
t
h
e
a
g
i
t
a
t
o
r
e
n
a
n
c
e
a
n
d
C
a
r
e
e
n
a
n
c
e
a
n
d
C
a
r
e
Check the beater shafts on a regular basis. An agitator
with defective shaft must no longer be used. Have the device
be repaired by the customer service.
S
S
Pull out power plug
Store unused equipment in a dry, locked place out of the
reach of children.
Before a longer period of storage carry out the following to
extend the machine's service life and ensure an easy operat-
ing:
− thoroughly clean the device
G
G
Please observe the enclosed terms of guarantee.
t
o
r
a
g
e
t
o
r
a
g
e
u
a
r
a
n
t
e
e
u
a
r
a
n
t
e
e
15

Publicité

Table des Matières
loading

Table des Matières