Sony VPL-ES3 Guide De Référence Rapide page 27

Symptom
The image extends beyond
the screen.
The picture flickers.
Indicators
Indicators
POWER SAVING
TEMP/FAN
LAMP/COVER
I/1 indicator
Cause and Remedy
The APA key has been pressed even though there are black edges
around the image.
c Display the full image on the screen and press the APA key.
c Adjust "Shift" on the INPUT SETTING menu properly.
"Dot Phase" on the INPUT SETTING menu has not been adjusted
properly.
c Adjust "Dot Phase" on the INPUT SETTING menu properly.
Status and Remedy
Lights up when the projector is in power saving mode.
Lights up when temperature inside the projector becomes unusually
high. Check to see if anything is blocking the ventilation holes.
Flashes when the fan is broken. Consult with qualified Sony
personnel.
Lights up when the lamp has reached the end of its life or becomes a
high temperature. Wait to cool down the lamp and turn on the power
again, or replace the lamp.
If it lights after you replaced the lamp, the electrical system may
have broken down. Consult with the qualified Sony personnel.
Flashes when the lamp cover or the air filter cover is not secured
firmly. Attach the cover securely.
Lights in red in standby mode. You can turn on the projector with
the I/1 key.
Lights in green when the power is turned on.
Flashes in green from the projector is turned on until the projector is
ready to operate. Also, flashes in green while the cooling fan runs
after the power is turned off with the I/1 key. During this time, you
will not be able to turn on the projector.
13
Troubleshooting
GB