EINHELL TH-MS 2112 T Mode D'emploi D'origine page 15

Anleitung_TH_MS_2112_T_SPK1__ 03.05.13 07:58 Seite 15
factors. The following risks may arise due to the
machineʼs design and setup:
Contact with the saw blade in the uncovered saw
n
zone.
Reaching into the running saw blade (cut
n
injuries).
Kick-back of workpieces and parts of
n
workpieces.
Saw blade fracturing.
n
Catapulting of faulty carbide tips from the saw
n
blade.
Damage to hearing if essential ear-muffs are not
n
worn.
Harmful emissions of wood dust when the
n
machine is used in closed rooms.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data
AC motor
Power
Operating mode
Idling speed n
0
Carbide saw blade
Number of teeth
Extractor socket
Base area
Weight
For use as a bench-type saw:
Saw bench
Cutting depth
Parallel stop Can be pivoted from -30° to + 30°
For use as a crosscut saw:
Swiveling range
Miter cut
Saw width at 90°
Saw width at 45°
Saw width at 2 x 45° (double miter cut) 40 x 23 mm
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Vibration emission value a
K uncertainty = 1,5 m/s
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
230V ~ 50 Hz
The specified vibration value can be used to compare
1200 W
the equipment with other electric power tools.
S1
The specified vibration value can be used for initial
4,500 rpm
assessment of a harmful effect.
ø 210 x ø 30 x 2.5 mm
24
Keep the noise emissions and vibrations to a
minimum.
Diameter 35 mm
Only use appliances which are in perfect working
n
400 x 325 mm
order.
10 kg
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
360 x 250 mm
necessary.
Switch the appliance off when it is not in use.
n
0 - 33 mm
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
-45° / 0° / +45°
may arise in connection with the equipment's
0° to 45° to the left construction and layout:
1. Lung damage if no suitable protective dust mask
120 x 55 mm
is used.
65 x 55 mm
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
uncertainty
= 2,162 m/s
h
2
GB
99 dB(A)
3 dB
112 dB(A)
3 dB
2
15