Cleaning Electrode; Burned-On Grime; Discoloration Of Burners - Gaggenau VG 295 CA Guide D'utilisation Et D'entretien

Appliance part / Recommended cleaning
surface
Stainless steel Apply dishwashing liquid with a soft,
surfaces damp cloth; dry off with a soft cloth. Only
use a little water for cleaning; no water
must penetrate penetrate into the
appliance.
If it is very dirty or discolored by heat, a
stainless steel cleaner is available from
your specialist dealer or our customer
service (order number 464524).
Pan supports Remove carefully for cleaning. Let soak
in the sink. Clean with a dishwashing
brush and dishwashing liquid.
Clean carefully around the rubber buffer
so that it doesn't come loose.
Rinse with clear water and carefully dry it
before putting it back in place.
Don't wash in the dishwasher!
Burner lid, Remove coarse grime with a damp cloth
burner ring, and dishwashing liquid. Apply brass
burner head polish in order to attain the original,
(brass) metallic gleam.
Check that the openings aren't plugged.
Make sure that small parts don't get lost.
Don't wash in the dishwasher!
Wok burner Clean with a dishwashing brush and
head (enameled dishwashing liquid and carefully dry it
cast iron) before putting it back in place.
Don't wash in the dishwasher!
Control panel Clean with a soft, damp cloth and some
dishwashing liquid; the cloth must not
bee too wet. Dry off with a soft cloth.
Control knob Clean with a soft, damp cloth and some
dishwashing liquid; the cloth must not
bee too wet.
,
CAUTION: Damage to device:
Don't remove control knob for
cleaning.

Cleaning electrode

A dirty electrode can cause malfunctions with ignition
or flame monitoring.
Clean with brush included if necessary. The electrode
is sensitive; clean carefully and don't twist or damage
it. Don't turn on the stovetop during cleaning.

Burned-on grime

For stubborn, burned-on grime, you can order a grille
cleaner gel from your specialist shop or our customer
service (order number 463582). It is suitable for pan
supports, burner parts and the stainless steel
stovetop. Leave on overnight if necessary. Bear in
mind the notes on the cleaner.

Discoloration of burners

After long use, the burners (burner lid, burner ring
and burner head) turn darker due to natural oxidation.
Proceed as follows to eliminate this discoloration:
1
Prepare a solution of equal amounts of white
vinegar with a maximum of 8% acid (typical
household vinegar) and warm water.
2
Immerse the burner parts in the solution for a
maximum of 10 minutes. Eliminate stubborn stains
with a cloth or sponge.
3
Then rinse the burner parts thoroughly with clear
water and dry them well prior to next use.
,
CAUTION:
Too strongly concentrated solution
or too long of contact with vinegar will damage
the surface of burner parts!
13