Random Orbit Sander Operation - Hitachi SV 13YA Instructions De Sécurité Et Mode D'emploi

English
By adjusting the dial, match the speed to the material and type of work.
Material
Paintwork:
Sanding
Repairs
(scratches, rust spots)
Stripping
Wood:
Softwood
Hardwood
Veneers
Metals:
Aluminium
Steel
Stainless steel
NOTE: Please use this table as a standard.

RANDOM ORBIT SANDER OPERATION

WARNING:
1. How to hold the random orbit sander
While gripping the housing, lightly press the
sander against the surface to be sanded so
that the sanding paper uniformly contacts
the surface, as shown in Fig. 6. DO NOT
apply excessive pressure to the sander while
sanding. Excessive pressure may cause
overload of the motor, reduced service life
of the sanding paper, and lowered sanding
or polishing efficiency.
2. How to move the random orbit sander
Move the sander by either moving it up and
down or by moving it in circles while
gradually progressing in a sideways
direction. (Figs. 7 and 8)
12
Rough grinding
180
120
40
60 – 80
60
240
80
60
120
Never apply water or grinding fluid when sanding. This could result in
electrical shock.
Grain
Fine grinding
400
240
80
240
180
320
240
240
240
Dial scale
3 – 6
2 – 4
2 – 4
3 – 6
3 – 5
2 – 4
2 – 4
3 – 6
3 – 6
Fig. 6
Fig. 7