Setting The Water Softener - ETNA VW549ZT Mode D'emploi

FIRST USE
Before using the dishwasher for the first time:
• Set the water hardness.
• Add 1 litre of water to the salt reservoir and then add 1.5 kg of dishwasher salt.
• Add rinse agent.
• Add detergent.

Setting the water softener

1. Open the door to switch on the appliance.
2. Press the Program button for more than 5 seconds to start the water softener set model
within 60 seconds after the appliance was switched on (the water softener and Rinse agent
warning lights will be on periodically when it get in the set model ).
3. Press the Program button to select the proper set according to your local environment, the
sets will change in the following sequence: H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the set up model.
Water softener table
Adjust the salt consumption according to the table below:
Water hardness
ºClarke
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
The manufactory setting: H4 (EN 50242)
Your local water authority can inform you how hard your mains water is.
ºdH mmol/l
0 - 5 0 - 0,94
6 - 11 1,0 - 2,0
12 - 17 2,1 - 3,0
18 - 22 3,1 - 4,0
23 - 34 4,1 - 6,0
35 - 55 6,1 - 9,8
setting Cycle
indicator light up
H1 Quick
H2 90 minutes
H3 90 min. + quick
H4 Eco
H5 Eco + quick
H6 Eco + 90 min.
Salt
consumption
(grams/cycle)
0
9
12
20
30
60
EN 9