Westfalia Automotive 306 255 Notice De Montage Et D'utilisation page 19

Installation instructions:
1a.) Please be extremely careful and avoid scratching the wing extensions during disassembly from the
Panda Cross model. The wing extensions are attached using double-sided adhesive tape and clips.
Take great care during disassembly, since the wing extensions are extremely fragile. The double-sided
adhesive tape cannot be reused once it has been removed.
1b.) Disassemble the rear bumper.
Remove the plugs at points "c" from underneath the chassis beams.
Unscrew and remove the nuts and washers at the attachment points "a" (internal attachment of the
bumper reinforcement).
2.) Push the towing device 1 onto the existing bolts at points "a" and attach it using the washers 8.5x21x2
and nuts M8. Attach the towing device 1 and the tail panel at point "b" using the bolt M8x30, washer
8.5x21x2 and nut M8.
Tightening torque for M8 at points "a" and "b" = 20 Nm
3.) From the top, push the mounting links 3 through the elongated holes in the chassis beams and
attach the towing device 1 at points "c" using the bolts M10x30 and washers 10.5x25x3.
Tightening torque for M10 at points "c" = 40 Nm
Push the ball bar 2 together with the sleeves 4 between the connecting plates at point "d" and attach it
4.)
using the bolts M12x120, washers 13x24x2.5 and nuts M12.
For the Panda Climbing and Panda Cross model, attach the plug holder 5 at point "d".
For the Panda 4x4 model attach the socket holder 5 at point "e" using the bolt M12x30, washer
13x24x2.5 nut M12.
Tightening torque for M12 at points
Tightening torque for M12 at points "e" = 65 Nm
5a.) Assemble the bumper to the vehicle.
For the Panda Climbing and Panda Cross model, saw a portion out of the underside of the bumper in
the middle as indicated on the supplied template. The line Y0 corresponds to the middle of the vehicle.
5b.) Assemble the wing extensions onto the Panda Cross model. Always use new double-sided adhesive
tape.
"
d" = 95 Nm
Subject to alteration.
19