Turning Power On/Off - Sharp PN-80SC5 Manuel D'installation

Caution
• When all connections are complete, turn on the power.
• Turn on the monitor first before turning on the computer or
playback device.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
A short interval may result in a malfunction.
Turning on the main power
When the main power is turned on, the power LED lights. Wait
until the screen is displayed.
Main power switch
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• For a complete electrical disconnection, pull out the main
plug.

Turning Power On/Off

Turning power on/off
Press the remote control POWER button or the monitor
POWER button to turn the power ON/OFF.
You can also turn the power ON/OFF by pressing the
MONITOR ON button/MONITOR OFF button on the remote
control unit.
Blue lit
Orange lit
• When the main power switch is off, the monitor cannot be
nOperation mode
When the monitor is turned on for the first time after being
shipped from the factory, the operation mode setting screen
will be displayed. Set it to MODE1 or MODE2.
MODE1 ... OFF IF NO OPERATION is set to 4HR.. (These
MODE2 ... Will perform standard operation.
Even after being set, changes can be made using
OPERATION MODE, located in the menu of the monitor. (See
OPERATION MANUAL.)
POWER
Power LED
Status
TIPS
turned on.
settings can not be changed.)
If there is no operation for 4 hours or more, the
monitor automatically enters standby mode.
OFF IF NO OPERATION is set to DISABLE. These
settings can be changed.
HDMI 1 D-SUB INPUT BL OFF VOL ─ VOL + FREEZE
Status of the monitor
Power on
Power off (Standby mode)
7
E