EINHELL BT-SD 3,6/2 Li Mode D'emploi D'origine page 9

Anleitung_BT_SD_3_6_2_Li_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Bit chuck
2. Lamp
3. Magnetic screw holder
4. ON/OFF switch for lamp
5. Battery capacity indicator
6. Switch for battery capacity indicator
7. Charging control lamp
8. Charging connection
9. On/Off switch
10. Clockwise/Counter-clockwise selector switch
11. Battery charger
12. Charging cable
13. Bag
14. 4 Bits
26.05.2009 15:28 Uhr
3. Proper use
The cordless screwdriver is designed for tightening
and undoing screws.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Motor power supply: 3.6 V DC
Idling speed: 200 min
Clockwise/Counter-clockwise:
Charge voltage for rechargeable battery:
Charge current for rechargeable battery: 300 mA
Battery charger supply voltage: 230 V ~ 50 Hz
Charging time: max. 5 hours
Battery type:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 58.8 dB(A)
pA
K uncertainty
pA
L sound power level 69.8 dB(A)
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Screwing without hammer action
Vibration emission value a ≤ 0.291 m/s 2
h
K uncertainty = 1,5 m/s 2
Seite 9
GB
-1
Yes
6 V DC
Li-Ion
0.4 kg
3 dB
3 dB
9