AEG SKS91000F0 Notice D'utilisation page 24

24 www.aeg.com
Problem
The lamp does not
work.
The compressor op-
erates continually.
The compressor
does not start im-
mediately after
pressing the COOL-
MATIC switch, or af-
ter changing the
temperature.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
The temperature in
the appliance is too
low/high.
Possible cause
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
Many products are stored
at the same time.
Solution
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
The compressor starts after
a period of time.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Store less products at the
same time.