Technical Data - AEG HC452021EB Notice D'utilisation

Problem
and a number come on.
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. TECHNICAL DATA

9.1 Rating plate
Model HC452021EB
Typ 56 FED 02 BO
Ser.Nr. .................
AEG
9.2 Cooking zones specification
Cooking zone
Left front
Right rear
Possible cause
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Nominal Power (Max heat set-
ting) [W]
1200
800 / 1600 / 2300
Remedy
Deactivate the hob and acti-
vate it again after 30 sec-
onds. If
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin-
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 595 442 02
220 - 240 V 50 - 60 Hz
Made in Germany
3.5 kW
Cooking zone diameter [mm]
145
120 / 175 / 210
ENGLISH 17
comes on again,