Publicité
GB
USES INSTRUCTIONS
Fig. 1 : In order to avoid an unnecessary effort on the awning, we suggest
the legs are located to the ground after 1m the canopy is
extended. According to the further unrolling the legs should be
moved forwards to assure a continuos support of the awning.
Fig. 2 : Unscrew the leg to allow its sliding out of the front profile.
Fig. 3 : Take the leg near its hinge-joint and pull it in a horizontal direction.
Fig. 4 : By this action the hinge will come out of the front profile and the
leg will slide out and swing downwards.
Fig. 5 : After unrolling the awning completely, fix the legs at the chosen
height.
Fig. 6 :To avoid that the awning could be taken up by a sudden wind,
causing a possible damage to the vehicle by the swinging of
the legs, it is necessary to secure the legs to the ground with
the provided hooks. As a supplementary security, we strongly
advise to make use of a storm cord at the upperside of each
support leg. or to anchor the awning with the Fiamma Tie-Down
Kit strap.
Fig. 7 : The support legs can also be fixed to the wall brackets. The wall
brackets can be fixed only in reinforced points.
Fig. 8 : We remind you that the awning is a sun protection, so please roll
up your awning in case of rain, wind of snow. Otherwise, please
take following precautions: Lower one side of your awning, so
that water can flow away and use the tension rafter (not included
for all awning lenghts).
Fig. 9 : Make sure that the awning can be correctly rolled up.
A damaged fabric does not allow a correct rolling up of the
awning.
Never use the awning with damaged canopy.
Wash the canopy with Fiamma BRILL.
In case of problems, please contact your next dealer or
the address here below.
®
8
®
Publicité
