Operating The Amplifier/Receiver - Sony Rm-Tp2 Mode D'emploi

Operating the amplifier/
receiver
You can operate a Sony 2 way amplifier/
receiver. You can also download the names of
components (inputs). Before operating, register
the Sony amplifier/receiver using the IR
SETUP function (page 10).
When performing the following procedure,
be sure to turn on the amplifier/receiver
and point the commander towards the IR
receptor on the amplifier/receiver.
To register a 2 way amplifier/
receiver
Use the RM SETUP screen.
Note
You cannot register the amplifier/receiver if it is not
set to use the 2 way remote system. Refer to "Setting
up the 2 way remote" in the operating instructions
supplied with the amplifier/receiver.
1
Touch RM SETUP.
2
Touch AMP REGIST.
3
Touch START.
The communication starts and the amplifier/
receiver is registered to the commander.
The registered amplifier/receiver name
appears in the screen. The amplifier/receiver
name also appears in the RM SETUP screen
as the current setting.
Note
If the amplifier/receiver name appears as "model
others", the amplifier/receiver is not registered
correctly. In this case, some 2 way operations may
not be possible.
To operate the amplifier/
receiver
1
Select the Sony amplifier/receiver in the
RM SELECT screen.
"1WAY 2WAY" appears.
Tip
When you can select several Sony amplifiers/
receivers in the RM SELECT screen, touch the
AMP icon that appears first.
2
Touch 2WAY.
The screen for the 2 way operation appears
and you can operate the amplifier/receiver
registered in the RM SETUP screen.
To download the names of components
(inputs), touch INPUT SELECT, then touch
INPUT NAME DOWNLOAD.
Notes
• 2 way operations may not be possible immediately
after turning on the amplifier/receiver.
• You cannot use the jog dial when using the 2WAY
screen.
• You cannot use the Learning function for the keys
in the 2WAY screen.
GB
21