Service Programme - Siemens TI3.3 Série Mode D'emploi

en Service programme
.

Service programme

E very so often – with the exact
S e r v i c e p r o g r a m m e
frequency depending on water
hardness and usage – the calc'nClean
button will light up. The display shows
"Calc'nClean required".
The appliance should be immediately
cleaned and descaled using the
programme.
Notes
Important: If the appliance is not
■
cleaned and descaled in good time,
it may be damaged.
Important: If the appliance is not
descaled and cleaned in time, it will
be locked.The display shows
"Device locked"
If the appliance is locked, it can only
be operated again once the service
programme has been carried out.
Caution! For each of the service
■
programmes, use Calc'nClean
descaling and cleaning agents as
described in the instructions and
observe the (relevant) safety
information.
Do not drink the liquids.
■
Never use citric acid, vinegar or any
■
vinegar-based agents to descale the
appliance.
For cleaning and descaling, only use
■
the tablets intended for such
purposes.They have been specially
developed for this appliance, and
new stocks can be ordered through
customer service. ~ "Accessories"
on page 11
Never insert descaling tablets or
■
other products into the brewing unit.
Never interrupt the service
■
programme.
Prior to starting a service
■
programme, remove, clean and
re-insert the brewing unit. Clean the
milk frother.
22
At the end of a service programme,
■
wipe down the appliance using a
soft, damp cloth to immediately
remove any descaler residue. This
residue may cause corrosion.
New sponge cloths may contain
■
salts. Salts can cause rust film on
stainless steel, so cloths must
always be washed out thoroughly
before use.
Using a water filter increases the
■
intervals until a service programme
needs to be performed.
If the service programme is
■
interrupted, e.g. by a power failure,
', calc'nClean and ) will light up
on the display.Proceed as described
in the section calc'nClean from item
10.