Faults - What To Do - Siemens KI51R Série Notice D'utilisation

en Faults – what to do?
3
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the
d o ? F a u l t s – w h a t t o
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the alarm button is lit
Appliance door is open.
Ventilation openings have been covered.
Appliance is not cooling, display and light are lit.
Demo mode switched on.
--------
28
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 24
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 29
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Hold down button alarm for 10 seconds until an
acknowledgement signal sounds. Wait and check
whether the appliance is cooling.