Faults - What To Do - Siemens KI42F Série Notice D'utilisation

en Faults – what to do?
3
Faults – what to do?
B efore you call customer service, use this table to check whether you can rectify the
F a u l t s – w h a t t o d o ?
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
40
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 31
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the after-sales service.
~ "Customer service" on page 42
Start the appliance self-test.
~ "Appliance self-test" on page 42
When the programme has ended, the appliance
switches over to normal operation.