Replacing The Light Bulb; Transportation And Changing Of Installation Position - VESTEL VEKF1015 Guide D'utilisation

Defrosting the freezer compartment
WARNING: Never use sharp metal tools, unless recommended by manufacturer for this
operation as they can damage the refrigeration circuit.
After a period of time, frost will build up in certain areas of the freezer compartment. The frost
accumulated in the freezer compartment should be removed periodically (use the plastic
scraper, if available).
Complete defrosting will become necessary if the frost layer exceeds 3-5 mm, to maintain
the efficiency of the freezer.
• The day before you defrost, set the thermostat dial to position "5" to freeze the food
completely.
• During defrosting, frozen food should be wrapped in several layers of paper and kept in
a cool place. The inevitable rise in temperature will shorten their storage life. Remember
to use the food within a relatively short period of time.
• Set the thermostat knob to position "•" and switch off the appliance.
• Leave the door open to accelerate defrosting. Remove any water from the compartment.
• Clean the interior by hand with lukewarm water and a little detergent.
• Never use abrasive products or aggressive cleaning agents.
• Dry the inside of the unit, plug it into the mains and set the thermostat knob to position
"5". After 24 hours, reset the thermostat to the desired position.

Replacing the light bulb

When replacing the bulb of the fridge compartment;
1. Unplug the unit from the power supply.
2. Press the hook in front of the light cover such as Figure 1 and
remove the light cover.
3. Change the present light bulb with a new one of not more than 15
W.
4. Replace the light cover and after waiting 5 minutes plug the unit.
Replacing LED lighting
If your refrigerator has LED lighting contact the help desk as this should
be changed by authorized personnel only.
TRANSPORTATION AND CHANGING OF
PART - 5.
INSTALLATION POSITION

Transportation and changing of installation position

• The original packages and foamed polystyrene (PS) can be retained if required.
• During transportation, the appliance should be secured with a wide string or a strong
rope. The instructions written on the corrugated box must be followed while transporting.
• Before transporting or changing the installation
position, all the moving objects (ie,shelves,crisper...)
should be taken out or fixed with bands in order to
prevent them from getting damaged.
! Carry your fridge in the upright position.
EN - 34 -
Figure 1
Figure 2