Hama KEY4ALL X3100 Mode D'emploi page 7

• Select Hama KEY4ALL X3100 and
enter the numeric code specified on
your device using the Bluetooth
keyboard. Press the Enter key to
confirm and wait until the keyboard is
shown as connected in the Bluetooth
settings on your terminal device. The
Bluetooth status LED (4) goes out.
®
• You can now use the Bluetooth
keyboard.
6.2 Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your
Bluetooth -capable terminal device
®
is on and Bluetooth
• Make sure that your
Bluetooth
-capable terminal device
®
is visible for other Bluetooth
devices.
• For more information, please refer
to the operating instructions of your
terminal device.
• Slide the OFF/ON switch (2) to the ON
position to switch on the Bluetooth
keyboard. The power status LED (6)
lights up.
• Press and hold the Connect button (1)
6
®
®
®
connection
®
is activated.
®
®
®
until the Bluetooth
begins to continually flash blue. The
keyboard is searching for a Bluetooth
connection.
• Open the Bluetooth
terminal device and wait until Hama
KEY4ALL X3100 appears in the list of
Bluetooth devices found.
®
• Select Hama KEY4ALL X3100.
• You can now use the Bluetooth
keyboard.
Note – Connection impaired
After the devices have been
paired once, the connection is
then established automatically. If
the Bluetooth
® connection is not
established automatically, check the
following:
• Check the Bluetooth
your terminal device to see whether
Hama KEY4ALL X3100 is connected.
If not, repeat the steps listed under
6.1 Bluetooth
®
• Check whether obstacles are
impairing the range. If so, move the
devices closer together.
® status LED (4)
® settings on your
®
settings of
®
pairing.
®