Avintage AV45XDZI-1 Notice D'utilisation page 40

SETTING THE TEMPERATURE CONTROL
•
You can set the temperature as required by pressing the « UP » or « DOWN » button. When you press the two buttons
for the fist time, the LED readout will show the original temperature set previously (the temperature preset at the factory
is 12°C/54°F).
•
The temperature will increase 1°C/1°F if you press the button « UP » once. The temperature will decrease 1°C/1°F if
you press the button « DOWN » once.
•
To view the « set » temperature at any time, press the « UP » or « DOWN » button, the "set" temperature will
temporarily "flash" in the LED display for 5 seconds.
•
The internal storage temperature will appear in the temperature display window.
MODEL 2 ZONES
Power
To turn this appliance on/off, press the bottom
the audible alarm when the alarm is on.
LIGHT
To control the inner light turn on/off.
« UP »
Used to increase (warm) the set temperature by 1°C/1°F.
« DOWN »
Used to decrease (cool) the set temperature by 1°C/1°F.
SELECTOR
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from Fahrenheit to
Celsius or from Celsius to Fahrenheit, press the button
SETTING THE TEMPERATURE CONTROL
The wine cooler has two temperature zones. The temperature settings of LOWER ZONE and UPPER ZONE are adjustable
with the range 5º-22ºC/40º-72ºF. It is recommended to set the LOWER ZONE to 12°-22ºC / 55-72ºF which is ideal for storing
white and red wines and the UPPER ZONE to 5-12ºC / 40-55ºF which is ideal for storing sparkling and white wines.
NOTE: The temperature set for the LOWER ZONE must always be the same or higher than that in the
UPPER ZONE. For optimal performance, the set temperature of the two zones should differ by at least
4°C.
• You can touch UP and DOWN mark to set the internal temperature for each zone. The degrees indicators will appear in
the display window marked
• When the unit is plugged in for the first time, the LED readouts will show the original temperature sets previously (the
preset temperature at the factory for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
and hold for 5 seconds. Pressing the
for UPPER ZONE and
for 5 seconds
for LOWER ZONE.
key once can switch off
40