AUDIOropa PROLOOP LOSplus Mode D'emploi page 24

4. Warranty
The PROLOOP LOSplus induction loop amplifier exhibits very high operating safety. If any malfunctions should
occur, despite correct operation, please contact your retailer or the manufacturer. The guarantee covers repairs
and shipping free of charge. The device must be returned in its original packaging – do not discard it. The gu-
arantee becomes invalid if the device is operated incorrectly or any repairs are attempted by unauthorized per-
sons (device seal is broken). Repairs will only be made on guarantee if you also include the correctly completed
guarantee card and a copy of the retailer's invoice/receipt. The device number must always be included.
5. Environmental protection / disposal
Disposal of used electrical and electronic devices (applicable in EU countries and other European coun-
tries with a separate collection system for these devices.) The symbol on the product or its packaging in-
dicates that this product should not be thrown into the regular household waste; it should be taken to a
recycling centre for electrical and electronic devices. When you dispose of this product correctly, you make a
contribution towards protecting the environment and your health. Incorrect disposal can pose a threat to the en-
vironment and your health. Material recycling also helps to reduce the use of raw materials. Further information
on recycling this product is available from your community, the municipal waste disposal department or the retail
outlet at which you bought the product.
6. PROLOOP LOSplus specifications
Power supply
Coverage
Induction loop output
Max. current
Max. voltage
Frequency range
Distortion
Cable connection
Outputs
Headphone jack
Slave Out
Inputs
IN 1
IN 2
100V-priority input
Slave IN
24 English
115 - 230 V AC, 50-60 Hz, 150 W
1000 m² acc. to IEC 60118-4
2x 12 A RMS, continuous 1 kHz, short-circuit-proof
2x 32 V RMS
100 – 5000 Hz (±3 dB)
< 1 %
2 screw connections on the rear panel of the device
3.5 mm (left audio channel for the Master output and
right audio channel for the Slave output)
6.3 mm jack, 0°/90° adjustable phase shift
XLR connector, optionally LINE-in (symmetric, sensitivity: 1V) or
Microphone-in (symmetric, sensitivity: 1mV)
Amplification adjustment, phantom current 15V can be added
XLR connector, optionally LINE-in (symmetric, sensitivity: 1V) or
Microphone-in (symmetric, sensitivity: 1mV)
Amplification adjustment, phantom current 15V can be added
Input for connection to a PA-System
6.3 mm jack