Cleaning, Maintenance And Storage; General Cleaning And Maintenance Work; Changing The Blade; Storage - Grizzly ARM 2434 Lion Mode D'emploi

Switch off the equipment after
work and in order to transport
it, disconnect the plug and wait
until the blade stops. There is a
risk of injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade
Switch off the device, pull the igniti-
on key (11) and wait for the blades
to come to a stop. There is a risk of
personal injury.
General Cleaning and Mainte-
nance Work
Do not hose down the lawnmo-
wer with water. Electric shock
hazard
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts,
bolts and screws are sitting firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced
1. Turn the equipment over.
2. Use sturdy gloves and hold
the blade firmly (16). Turn the
blade screw (18) anticlockwise
off of the motor spindle using a
screwdriver.
3. Install the new blade in the
reverse order. Ensure that the
blade is positioned correctly and
the screw tightened firmly.

Storage

• Keep the equipment dry and out
K
of reach of children.
• Release the tightening lever (2)
and fold the bow-shaped handle
(1) and lower bar (3) together
so that the device takes up less
space. The cables may not be
jammed when you do this.
• Allow the motor to cool before
storing the equipment in a confi-
ned space.
• Do not cover the equipment with
nylon bags as moisture could
build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.
GB
33