General Description; Function Description; Summary; Assembling Instructions - Grizzly ARM 2434 Lion Mode D'emploi

• If the power cable for this
equipment is damaged, it must
be replaced by the manufactu-
rer, a customer service agent
of the same or a similarly qua-
lified person in order to prevent
hazards.

General Description

Function Description

The cordless lawn mower has a cutting
tool, which turns parallel to the cutting le-
vel. It features a powerful electrical drive,
a sturdy plastic casing, a safety switch, a
collision guard as well as a grass box.
Additionally, the equipment is height
adjustable to 6 levels and has smooth-
running wheels.
For the function of the operating parts,
please refer to the descriptions below.
The illustration how to handle the
appliance can be found on page
2 - 3.

Summary

1 Curved handle
A
2 Tightening lever
3 Lower bar
4 Grass box
5 Collision guard
6 Wheels
7 Housing
8 Rechargeable battery
9 Cable holder
10 On/Off switch
11 Ignition key
12 Safety bracket
13 Connection cable
14 Cutting height adjuster

Assembling instructions

• Alwayas wear cut-protection gloves
• Undertake only work with which you
are confident.
• In case of uncertainty, contact a speci-
alist or contact our service directly

Install lower bar:

1. Pull the ends of the lower bar
B
(3) slightly apart and set the-
se up on the screw thread to
the right and left of the device
housing.
Position the enclosed washers
and untwist the lower tightening
lever (2).
2. Lock the tightening lever (2) by
pressing it in the direction of
the bar (3). The tightening lever
must be tightened and fit the
bar so that a tensioning with
medium force can be carried
out. Otherwise, the tightening
levers must be turned clockwise
for tensioning them or anti-
clockwise to loosen them.

Install curved handle:

C
1. Fasten the bow-type handle (1)
with the enclosed screws, the
washers and the upper tighten-
ing levers (2) both right and
left of the lower bar (3). Two
positions are possible. There
are two possible positions.
2. Turn the tightening lever (2) in
the clockwise direction.
3. Lock the tightening lever (2) by
pressing it in the direction of the
bar (3). The tightening lever fit
the bar so that a tensioning with
GB
29