Husqvarna TC138 Manuel D'utilisation page 12

To install the steering wheel
1. Install the steering shaft extension (A) on the
steering shaft (B).
K
J
I
H
G
2. Put the top steering bracket (C) onto the steering
shaft extension until it is flat against the
dashboard.
3. Install the 4 screws (D) with a screwdriver but do
not tighten the screws in this step.
4. Tighten the 4 screws with your hand until they
are flat against the top steering bracket.
5. Use a screwdriver to tighten the screws 90°
more.
CAUTION:
screws too much.
6. Install the shaft cover (E). Make sure that the
guide tabs in the shaft cover are in the correct
positions.
7. Remove the steering wheel adapter (F) from the
steering wheel (G).
8. Put the steering wheel adapter on the steering
shaft extension.
9. Put the steering wheel on the steering shaft
extension.
10. Make sure that the front wheels and the steering
wheel are aligned forward.
11. Install the large flat washer (H), the lock washer
(I), and the bolt (J). Tighten the bolt fully.
12. Attach the center cover (K) to the steering wheel.
The center cover is attached with snap locks.
To install the seat
1. Remove, but do not discard, the hardware which
attaches the seat to the cardboard package.
2. Remove and discard the cardboard package.
Note:
Do not remove the tape from the
adjustment handle until the seat is correctly
attached to the product.
12
F
A
C
D
E
B
Do not tighten the
3. Connect the wire connector to the safety switch
(A) on the seat.
C
D
B
4. Put the seat on the seat pan (B) and put the
middle plastic piece (C) into the middle slot
assembly hole (D).
5. Push the seat rearward until the 2 front plastic
pieces (E) are aligned with the front slot
assembly holes. Push down the seat to engage
the plastic pieces in the slots. Push the seat
rearward.
2
6. Fold the seat forward and install the 2 bolts (F)
and the 2 washers (G).
F G
Note:
Make sure that the 2 front plastic pieces
(H) are fully engaged in the seat pan.
E
A
1
H
I
1706 - 002 - 11.10.2021