Audio Control; Speaker Setting - Kenwood KDC-3025 Mode D'emploi

Sound setting
Flat
User memory
Rock
Pops
Easy
Top 40
Jazz
• User memory: The values set on the 'Audio Control'
(page 9).
• Each setting value is changed with the 'Speaker
Setting' (page 9).
First, select the speaker type with the Speaker setting.

Audio Control

1
Select the source for adjustment
Press the [SRC] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display
Bass level "BAS"
Middle level "MID"
Treble level "TRE"
Balance "BAL"
Fader "FAD"
Volume offset "V-OFF"
Loudness "LOUD"
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
5
Exit Audio Control mode
Press the [AUD] button.
Display
"FLAT"
"USER"
"ROCK"
"POPS"
"EASY"
"TOP 40"
"JAZZ"
Range
–8 — +8
–8 — +8
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–8 — ±0
ON/OFF

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "ALL OFF" display.
2
Enter Speaker Setting mode
Press the [Q] button.
3
Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting
switches as shown below.
Speaker type Display
OFF "SP OFF"
For 5 & 4 in. speaker "SP 5/4"
For 6 & 6x9 in. speaker "SP 6*9/6"
For the OEM speaker "SP OEM"
4
Exit Speaker Setting mode
Press the [Q] button.
9
|
English