Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DRIVE CONTROL (See Fig. 6)
•
Self-propelling is controlled by pulling either drive
control lever rearward to the handle. The further
toward the handle a lever is pulled, the faster the unit
will travel.
•
To stop forward motion without stop ping blade, re lease
a drive control lever.
NOTE: If after releasing the drive control the mower will
not roll backwards, push the mower forward slightly to
disengage drive wheels.
OPERATOR
PRESENCE
CONTROL BAR
TO ENGAGE DRIVE CONTROL
DRIVE CONTROL DISENGAGED
DRIVE CONTROL ADJUSTMENT (See Fig. 7)
Over time, the drive control system may become "loose",
resulting in decreased speed. There is a turnbuckle on
the drive control housing to increase tension on the drive
cable. Pro ceed as follows:
1. Turn unit off and disconnect spark plug wire from spark
plug.
2. Rotate turnbuckle on drive control to increase drive
speed.
3. Operate mower to test drive speed. Readjust as re-
quired.
4. If condition fails to improve after the above steps
(forward speed remains the same), your drive belt is
worn and should be re placed.
OPERATION
DRIVE
CONTROL
LEVERS
FIG. 6
ADJUSTMENT TURNBUCKLE
TO ADJUST CUTTING HEIGHT (See Fig. 8)
Raise wheels for low cut and lower wheels for high cut,
adjust cutting height to suit your requirements. Me di um
position is best for most lawns.
•
To change cutting height, squeeze adjuster lever to ward
wheel. Move wheel up or down to suit your re quire-
ments. Be sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when plate tab inserts
into hole in lever. Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the plate tabs.
ROTATE LEVER BACKWARD
TO LOWER MOWER
ROTATE LEVER FORWARD TO RAISE MOWER
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging:
REAR BAGGING (See Fig. 9)
•
Lift handle to vertical position. The rear door will rise
to allow easy removal and replacement of the grass
catcher. Place the grass catcher frame hooks onto
the grass bag brackets.
•
To convert to mulching or dis charg ing operation,
remove grass catch er and close rear door.
SIDE DISCHARGING (See Fig. 10)
•
Rear door must be closed.
•
Open mulcher door and install dis charge deflector
under door as shown.
•
Mower is now ready for side discharging operation.
•
To convert to mulching or bagging operation, dis charge
deflector must be removed and mulcher door must be
closed and locked.
8
FIG. 7
PLATE
TAB
LEVER
FIG. 8
Publicité
Chapitres
Table des Matières
