Trou Ble Shoot Ing - Husqvarna HD800AWD/BBC Manuel De L'opérateur

See appropriate section in manual unless directed to a Husqvarna or other authorized repair center.
PROBLEM
Does not start 1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is disconnected.
6. Bad spark plug.
7. Loose blade or broken blade adapter.
8. Control bar in released position.
9. Control bar defective.
10. Fuel valve lever (if equipped) in OFF position. 10. Turn fuel valve lever to the ON position.
11. Weak battery (if equipped).
12. Disconnected battery connector (if equipped). 12. Connect battery to engine.
TROUBLESHOOTING POINTS
CAUSE CORRECTION
1. Clean/replace air filter.
2. Fill fuel tank.
3. Empty fuel tank and refill tank with fresh,
clean gasoline.
4. Empty fuel tank and refill tank with fresh,
clean gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tight en blade bolt/replace blade adapter.
8. Depress control bar to handle.
9. Replace control bar.
11. Charge battery.
18