Sony Handycam DCR-PC330E Mode D'emploi page 96

The starting point of the first program is set,
and the upper part of the program mark
changes to light blue.
[IMAGE SIZE] appears when
recording on a "Memory Stick."
9
Search for the end of the first scene
that you want to record on your
camcorder, then pause playback.
You can adjust the position with
(frame).
10
Touch [MARK OUT].
The ending point of the first program is set,
and the lower part of the program mark
changes to light blue.
11
Repeat steps 7 to 10 and create
programs.
12
Set your VCR to recording pause.
Skip this step if you are connected via an
i.LINK cable or recording on a "Memory
Stick."
13
Touch [START].
96
Dubbing/Editing
14
Touch [EXEC].
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during the search and
[EDITING] appears during editing.
When a program is recorded, the program
mark changes from orange to light blue.
When all programs have been recorded, the
/
program editing operation stops
automatically.
To cancel recording, touch [CANCEL].
To end Digital program editing
Touch [END].
To save a program without using it to
record
Touch [END] in step 13.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 6 in "Recording the
selected scenes as programs" (p. 95),
then touch [UNDO].
2
Touch [DEL 1MARK] to delete the last
set program. Or, touch [ALL ERASE] to
delete all the programs.
3
[EXEC]
Touch
The programs are deleted.
To cancel this operation, touch [CANCEL].
b Notes
• You cannot set starting point or ending point on a
blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 11 on
p. 92, and set the [IR SETUP] code.
.