Sony Handycam DCR-PC330E Mode D'emploi page 42

[MTCAM CHROMA] (Memory Chroma
key)
You can have the movie swap into the blue area
of a still image such as an illustration or into a
frame with a blue area enclosed by the frame.
Movie
Still image
Blue
1
Check that you have a "Memory
Stick" with the still image to be
superimposed and a tape (only if you
are recording on tape) in your
camcorder.
2
Slide the POWER switch repeatedly to
select the CAMERA-TAPE mode
(when you are recording on a tape) or
the CAMERA-MEMORY mode
(when you are recording on a
"Memory Stick").
3
Touch .
4
Touch [MEMORY MIX].
If the item is not displayed on the screen,
touch / . If you cannot find it, touch
[MENU], and select it from the
APPLI.) menu.
The still image stored in the "Memory
Stick" will be displayed on the thumbnail
screen.
Thumbnail screen
5
Touch /
image to overlap.
42
Recording
(PICT.
to select the still
6
Touch the desired effect.
The still image is superimposed on the
movie which is currently displayed on the
LCD screen.
7
Touch (decrease)/
to adjust the following.
For [MTCAM LUMI.]
The color scheme of the bright area in the
still image which is to be swapped into a
movie. When you want to record only the
still image stored on the "Memory Stick" to
a tape, touch
[MTCAM LUMI.] until the bar indicator
is extended fully to the right side.
For [CAMTM CHROMA]
The color scheme of the blue area in the
movie.
For [M CAM CHROMA]
T
The color scheme of the blue area in the still
image which is to be swapped into a movie.
8
Touch twice.
appears.
9
Start recording.
When you are recording on a tape
Press START/STOP.
When you are recording on a
"Memory Stick"
Press PHOTO fully.
To cancel MEMORY MIX
Follow steps 1 to 4, then touch [OFF] in step 5.
b Notes
• When the overlapping still image has a large amount
of white, the image in the thumbnail screen may not
be clear.
(increase)
on the screen in