DeWalt DCB116 Guide D'utilisation page 7

respective battery port will blink continuously, indicating that the
charging process has started.
5. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
6. A solid yellow LED (e) indicates that the battery in that port
is waiting to be charged. Only one battery charges at a time.
The battery pack in need of the least amount of charge will be
charged first.
Indicator Light Operation
Charging
Fully Charged
Hot/Cold Pack Delay
Waiting to Charge
Charge Indicators
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold Pack Delay feature: when the
charger detects a battery that is hot, it automatically starts a Hot
Pack Delay, suspending charging until the battery has cooled. After
the battery has cooled, the charger automatically switches to the
Pack Charging mode. This feature ensures maximum battery life.
The red light flashes and the yellow light remains on while in the Hot/
Cold Pack Delay mode.
WAITING TO CHARGE
The DCB116 stores six batteries, but will only charge one battery at
a time. While a battery is charging, the remaining batteries in need
of charging will be indicated with a solid yellow light. The yellow light
will remain illuminated indicating the waiting-to-charge mode. The
yellow light will go out once charging begins and the red charging
light will begin to blink.
LEAVING THE BATTERY PACK IN THE CHARGER
The charger and battery pack can be left connected with the charge
indicator showing Pack Charged.
Important Charging Notes
1. Longest life and best performance can be obtained if the
battery pack is charged when the air temperature is between
65 °F and 75 °F (18–24 °C). DO NOT charge the battery pack
in an air temperature below +40 °F (+4.5 °C), or above +105 °F
(+40.5 °C). This is important and will prevent serious damage to
the battery pack.
2. The charger and battery pack may become warm to touch while
charging. This is a normal condition, and does not indicate a
problem. To facilitate the cooling of the battery pack after use,
avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check operation of receptacle by plugging in a lamp or other
appliance;
b. Check to see if receptacle is connected to a light switch
which turns power off when you turn out the lights;
c. Move charger and battery pack to a location where the
surrounding air temperature is approximately 65 °F–75 °F
(18–24°C);
d. If charging problems persist, take the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
5