Shelves - Avantgarde vinopazzo LBWC27SS Manuel D'utilisation

NOTES
If too many bottles are put in at once or the door has not been closed tightly, the unit will
display the "HI" signal on the display panel. This is normal. Wait, and after having the door
closed for 5 minutes the "HI" display will disappear.
It is normal that the cabinet shows "HI" or "LO" from time to time. If it occurs frequently or lasts
for a long time, you can restart the unit by unplugging it, then re-plugging after 5 minutes. If the
problem occurs again after restarting, please contact customer service.
Before reconnecting the power, wait 3 to 5 minutes. Otherwise you could damage your
appliance. If you attempt to start the appliance before the end of this time delay, the appliance
will not turn on.
If you turn on the appliance for the first time or after a restart, or after it has been out of
operation for a long time, there may be a temperature difference between the temperature
inside the appliance and that on the LED display. This is a normal; the unit needs an activation
period. Leave the appliance turned on for several hours and the temperature will stabilize itself.

SHELVES

To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
LBWC27SS UNIT
For easy access to the bottles, you must pull the shelves approximately 1/3 out of the rail
compartment.
To remove the shelves out of the rail, pull each shelf approximately 1/3 out of the rail
compartment. Use a long flat screwdriver to press down the right plastic notch (as shown in
Figure A) and at the same time lift the left plastic notch as shown (in Figure B). Then proceed to
pull out the shelf slowly.
NOTE: DO NOT ATTEMPT TO REMOVE A SHELF WHEN IT IS FILLED.
Figure A: right side notch
Figure B: left side notch
24