Language Menu; Sensor Calibration Menu - Lofrans GALAXY 703 Manuel D'installation Et D'utilisation

4.6 Language menu

Language
L a n g u a g e
E x i t

4.7 Sensor calibration menu

Once the "Sensor Detection" function has recognised a "Standard" type sensor instead of a "Project" sensor, when
the "Sensor Calibrat." menu is entered again, the menu options will "configure" themselves according to the sensor
detected.
Standard and X.. Project series sensor menu
(magnet and sensor placed on barbotin)
Barbotin Circumference
In this row the user must enter the circumference of the
gipsy (in centimetres or inches).
Use the Table 1 provided to calculate the circumference.
Settable values: centimetres or inches.
Default value, 33 cm.
Select with
Select value with
Confirm with
Exit
To return to the settings menu.
8
www.busse-yachtshop.de | info@busse-yachtshop.de
Use the
Language
The user may select the display language:
E n g l i s h
Italian, English, French, German,
Spanish, Greek
Exit
To return to the settings menu.
Use the
Sensor Selection
Press
Confirm with
(DOWN) or (UP) key to move around the parameters
(DOWN) or (UP) key to move around the parameters
or
1000 – 1500 –2000 W Project series sensor menu
(magnet and sensor placed on motor)
Reduction Factor
In this row the user must enter the reduction factor.
See next Table 2 for the correct value to be entered
Default value, 57.
Confirm with
GALAXY 703
Select with
Select value with
Confirm with
Confirm with
Select with
Sensor Selection
STD
PROJ