RedMax GZ5000 Manuel D'utilisation page 3

17. Chain break and front handguard
18. Decompression valve
19. Right handguard
20. Throttle trigger
21. Product and serial number plate
22. Clutch cover
23. Measurement scale (cm)
24. Oil pump adjustment screw
25. Chain catcher
26. Spiked bumper
27. Transportation guard
28. Operator's manual
29. Combination wrench
30. Vibration damping system, 3 units
Symbols on the product
Stop.
Be careful and use the product correctly.
This product can cause serious injury or
death to the operator or others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Always wear approved protective helmet,
approved hearing protection and eye
protection.
Use 2 hands to operate the product.
Do not operate the product with one hand
only.
Do not let the guide bar tip touch an object.
Warning! Kickback can occur when the
guide bar tip touches an object. A kickback
causes a lightning fast reverse reaction that
throws the guide bar up and in the direction
of the operator. Can cause serious injury.
Chain brake, engaged (right). Chain brake,
disengaged (left).
1519 - 002 - 08.07.2020
Decompression valve: The valve is to
reduce the pressure in the cylinder and
make starting easier. You should always use
the decompression valve when starting the
machine.
Choke.
Air purge bulb.
Chain oil.
Fuel.
Adjustment of the oil pump.
XX
Computed kickback bar stopping angle
without actuated chainbrake, CKA wob.
XX
Computed kickback bar stopping angle with
actuated chainbrake, CKA wb.
yyyywwxxxx
RedMax H25
10 T
18"
Note: Other symbols/decals on the product refer to
certification requirements for some markets.
The rating plate shows se-
rial number. yyyy is the
production year and ww is
the production week.
Recommended cutting
equipment in this exam-
ple: Guide bar length 18
in, maximum nose radius
10 Teeth and chain type
RedMax H25.
3