RedMax BCZ3050S Manuel D'utilisation page 10

engine knocking, which causes engine
damages.
Two-stroke oil
• For best results and performance use RedMax two-
stroke oil.
• If RedMax two-stroke oil is not available, use a two-
stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
5
10
15
20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
10
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
5. Carefully shake the fuel mixture.
To fill the fuel tank
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
Two-stroke oil,
liter
2% (50:1)
0.10
0.20
0.30
3. Shake the container and make sure that the fuel is
0.40
4. Remove the fuel tank cap slowly to release the
US fl. oz.
5. Fill the fuel tank.
2 ½
6 ½
12 ⅞
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
Note: To see where the fuel tank is on your product,
refer to
To start the engine
1. Put the product on a flat and stable surface. Keep
container.
CAUTION: Do not mix fuel for more than 1
month at a time.
WARNING: Obey the procedure that follows
for your safety.
fully mixed.
pressure.
CAUTION: Make sure that there is not
too much fuel in the fuel tank. The fuel
expands when it becomes hot.
refueling area and fuel source before you start the
engine.
Introduction on page 2 .
the cutting attachment off the ground.
1561 - 003 - 05.10.2020