Publicité
Les langues disponibles
Les langues disponibles
Wall Mounting
These chargers are designed to be wall mountable or to
sit upright on a table or work surface. If wall mounting,
locate the charger within reach of an electrical outlet,
and away from a corner or other obstructions which may
impede air flow. Use the back of the charger as a template
for the location of the mounting screws on the wall. Mount
the charger securely using drywall screws (purchased
separately) at least 1" (25.4 mm) long, with a screw head
diameter of 0.28–0.35" (7–9 mm), screwed into wood to an
optimal depth leaving approximately 7/32" (5.5 mm) of the
screw exposed. Align the slots on the back of the charger
with the exposed screws and fully engage them in the slots.
Versatrack™
CRAFTSMAN chargers can be mounted to the wall using
CRAFTSMAN Versatrack™ Trackwall. Hooks and accessories
are sold separately. Please refer to the Versatrack™ Trackwall
accessory sheet for further information.
Intended Use
This pole hedge trimmer is intended for residential
landscaping applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Joining Trimmer Head Module to Handle
Module (Fig. A, B)
Combining the handle module
module
creates a pole trimmer that is approximately 6'
12
(1.8 m).
1. Align the groove on the outside of the coupling end of
the handle module
11
with the tongue on the inside of
the coupling end of the trimmer head module
2. Slide the threaded sleeve
module down as far as possible and rotate the sleeve
clockwise until it stops and completely covers the
orange threads.
WARNING: Always check to make sure that the sleeve
is completely threaded on and that the threads are no
longer visible. Not threading the sleeve completely on
could result in the modules becoming disconnected
creating a hazardous condition. Periodically check the
connections to insure that no threads are visible.
11
to the trimmer head
12
.
6
on the trimmer head
Detaching Trimmer Head Module (Fig. B)
WARNING: Sharp moving blade. To prevent
accidental operation, insure that battery is
disconnected from the handle before performing the
following operations. Failure to do this could result in
serious personal injury.
When detaching the modules rest the handle module
on the ground and grasp the center of the trimmer head
module
with one hand. Use your other hand to loosen
12
the threaded sleeve and then pull the two halves apart.
Fig. B
12
6
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. C)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
3
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button
13
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
English
11
11
into the tool handle, align the
9
Publicité
