AEG HK633220FB Notice D'utilisation page 30

30 www.aeg.com
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
The heat setting changes
between two levels.
The sensor fields be-
come hot.
comes on.
comes on.
comes on.
and a number come
on.
Problem Possible cause
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot. Let the cooking zone be-
The highest heat setting
is set.
The Power management
is activated.
The cookware is too
large or you put it too
near to the controls.
The Automatic Switch
Off operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cook-
ing zone.
There is an error in the
appliance.
Remedy
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on
the rear cooking zones if
necessary.
Deactivate the appliance
and activate it again.
Refer to the chapter
"Daily Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Move cookware to a
smaller cooking zone.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If comes on again,
speak to the service cen-
tre.