GE AEL24 Série Manuel D'utilisation Et Instructions D'installation page 11

PREPARE THE CASE (continues)
4
Attach the side retainers to the case using 6 type
E
A screws .
PREPARE THE WINDOW AND INSTALL
5
THE CASE
A
Cut the window sash seal to the proper length .
Peel off the backing and attach the seal to the
underside of the window sash .
Open the window and mark the center of the
B
window sill .
Carefully slide the case into the window and
C
center the case . Lower the window behind
the top mounting rail . Pull the bottom of the
case forward so that the bottom mounting rail
is tight against the back of the window stool .
Mount the case to the window sill using 2 type
C screws . Drill pilot holes, if necessary .
Stool
Installation Instructions
2 type C screws
PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
Assemble the V-support and V-support bracket
D
with Type F nut and bolt
Left
Sill angle
bracket
V-support Type
F bolt and nut
Position the V-supports
E
on the case bottom so
that they will be near the
outside wall . Attach a
V-support to each side of
the bottom of the case with
Type E bolts, 2 for each
support .
F
Adjust sill angle brackets to rest on sill .
Extend the left and right accordion panels
G
to the vertical window sashes . Drill pilot holes and
attach the top corners with 2 type C screws .
Type C
screw
11
Type E bolt
and nut
Right
V-support
Sill
Bracket
Type C
screw