Mounting On Cruise 2 - Torqeedo Travel 400 Mode D'emploi

• If the motor does not develop sufficient propulsion after you have
replaced the propeller, tighten the inner self-locking nut by 90°
(a quarter turn).

6.5 Mounting on Cruise 2.0

1. Slot the 25 mm diameter plate spring onto the gear shaft. Make sure the opening of the
plate spring faces toward the end of the shaft (i.e. the plate spring curves toward the
pylon).
2. Insert the 3 x 27 A2 cylinder pin into the crossways borehole of the gear shaft.
3. Put the propeller onto the gear shaft and turn it until the cylinder pin clicks into the
recess of the propeller.
4. Screw the M10 A2 self-locking nut onto the gear shaft. Tighten the screw.
5. The next steps differ depending on whether your sacrificial anode is designed with a
screw thread or as a disc.
• Sacrificial anode with thread (Fig. 2): Place the 8.5 x 2 O-ring onto the gear shaft and
then screw on the sacrificial anode by hand.
• Disc-type sacrificial anode (Fig. 3): Place the sacrificial anode onto the gear shaft and
secure it with one of the self-locking nuts you removed during dismantling.
6. Replacing the propeller
Operating Manual Propeller
15