Hama 00179804 Mode D'emploi page 12

6.3 LEARNING OF KEYS
1. Press and release the desired key on the original remote control which you
want the command to be learned. The LED at your replacement remote will
flash to confirm that the information has been received.
2. Then press and release the target key on the remote control you want
learned.
3. If the LED flashes 3 times and then remain on, the command has been
learned successfully.
4. Repeat these steps to learn other key functions.
5. Press the [MUTE] and [VOL-] buttons to save all learnt functions and to exit
the learning mode.
Note
• While replacing the batteries, the remote control will keep the functions of
the learned keys.
6.4 CLEARING OF LEARNED KEYS
6.4.1 CLEARING OF ONE LEARNED KEY
1. Press and hold [MUTE] and [VOL+] keys for 5 seconds until the LED will
be lit.
2. Enter the code [9] [8] [1], the LED will flash 2 times and then remain on.
3. Press and release the desired key at the replacement remote control which
you want to clear the learned command. If the LED flashes 3 times, the
learned command has been cleared successfully.
6.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold [MUTE] and [VOL+] keys for 5 seconds until the LED will
be lit.
2. Enter the code [9] [8] [2], the LED will flash 2 times and then remain on.
3. Press and release the [OK] key at the replacement remote control. If the LED
flashes 3 times, all commands have been cleared successfully.
7. EASY Mode
This remote control is equipped with an EASY Mode. Thus you could reduce
the functionality of the remote control to its basic functions. It avoids that the
TV Settings are changed by mistake.
During the EASY Mode you still could use following keys:
POWER TV ON / OFF
VOL Change your TV's volume
TV Mute
CH Channel up/down
0-9 Numeric keys 0 – 9 to enter channel numbers
TTX/MIX Teletext ON / OFF / MIX
Use to select a variety of on screen options
GUIDE Show the Electronic Program Guide
(if supported by the TV)
Input signal source
Turn off the menu of the selected product
TV Switch to signal source TV
7.1 Enter EASY Mode
1. Press and hold [MUTE] and [VOL+] keys for 5 seconds until the LED will
be lit.
2. Enter the code [9] [7] [0], the LED will flash two times and then remain
on.
3. Press and release the [OK] key, if LED flash 3 times, you have entered the
EASY Mode successfully.
10
5
5
5