Cleaning The Milk System - Siemens TE6 Série Mode D'emploi

en Care and daily cleaning
● Always immediately remove any limes-
cale, or residues of coffee, milk, cleaning
or descaling solution. It is possible for
corrosion to form underneath such
deposits.
● New sponge cloths may contain salts that
can cause rust films to form on stainless
steel, so such cloths should always be
thoroughly rinsed before use.
● Pull the drip tray 17 and coffee grounds
container 17c towards the front and
remove them. Take off the panel 17a and
drip plate 17b. Empty and clean the drip
tray and coffee grounds container.
● Wipe out the inside of the appliance
(holder, trays) and the drawer for ground
coffee (this cannot be removed).
● Remove the float 17d and clean it with
a moist cloth (depends on the type of
appliance).
L
Do not put the following parts in the
dishwasher:
Panel of drip tray 17a, cover 4a, brewing
unit 14, water tank 5 and aroma cover 10.
M
The following parts may be cleaned in
the dishwasher:
Drip tray 17, drip plate 17b, coffee grounds
container 17c, measuring spoon 8 and
the upper and lower parts of the milk
system 4b.
F
Important: The drip tray 17 and
coffee grounds container 17c should
be emptied and cleaned every day in
order to prevent deposits.
F
If the appliance is cold when
switched on, or if it is switched off
after dispensing coffee, it rinses auto-
matically. The system is therefore
self-cleaning.
16
F
Important: If at any time the appli-
ance is not used for a lengthy period
(e.g. holiday), clean the entire appli-
ance thoroughly, including the milk
system 4b and brewing unit 14.

Cleaning the milk system

A
Be sure to clean the milk system 4b
every time you make a drink involving
milk!
You can clean the milk system 4b automat-
ically using programme E or by
hand.
Automatic cleaning:
● Touch E and then R.
● Place an empty glass under the beverage
outlet 4 and stand the end of the suction
pipe 4d in it.
● Touch C to begin running the
programme.
The milk system 4b will now clean itself
automatically.
● Then empty the glass and clean the
suction pipe 4d.
Cleaning by hand:
B
Risk of burns!
The milk system 4b becomes
extremely hot. After use, always let
them cool down before you touch
them.
Take the milk system 4b apart to clean it:
● Push the beverage outlet 4 right down.
● Take off the cover 4a towards the front
and pull off the milk tube.