Use & Operation - Honeywell MF08CESWW Manuel Du Propriétaire

Temperature and Time Setting Indicator Display
Power Control
The Power Control turns the unit on and off. When switched
on the unit will start on Auto mode.
Warning Light
Condensed water may accumulate in the unit. If the internal
tank becomes full, the Warning Light will shine red and the
unit will not operate until the unit has been drained.
Mode Indicator Light
Cooling Mode - Blue
Dehumidifying Mode - Orange
Fan Mode - Green
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
O/I
MODE
Power Control
Mode Indicator Light
USE & OPERATION
Receiving Sensor
ALARM
Warning Light
Temperature and Time Setting Indicator Display
The indicator displays:
• Current temperature.
• Thermostat setting while changing the temperature.
• Timer hours during Timer setting.
When ambient temperature is higher than 122°F, the
indicator shows "HI".
When ambient temperature is lower than 32°F, the
indicator shows "LO".
Note:
• Once thermostat or timer has been set the indicator
will continue to display ambient temperature after 5
seconds.
• When setting the thermostat or timer the indicator
will be flashing.
10