Use And Operation - Honeywell MN10CCD Série Mode D'emploi

USE AND OPERATION

CONTROL PANEL
(6) (5)
1) Power Control / Standby Mode
2) Warning Light (when flashing)
3) Mode Control
FUNCTION BUTTONS
POWER CONTROL
The Power Control turns the unit on and off. When the unit is plugged in, this button lights up indicating it
is in a Standby Mode ready to be switched on anytime.
WARNING LIGHT
Condensation may accumulate in the unit.
If the internal tank becomes full, the Power Control light will flash and the unit will not operate until
the unit has been drained (refer to Water Condensation Drainage).
After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
MODE CONTROL
Settings: Air Conditioning, Heating*, Dehumidifying, Fan.
The corresponding indicator light will illuminate to indicate the current mode setting.
•
Air Conditioning Mode
Adjust fan speed and air temperature to suit your desired comfort level.
Temperature setting range is 16°C - 32°C (61°F - 89°F).
(4)
EN
(4)
STOP
4) Timer / Temperature Set Controls
5) Fan Speed Control
*Applicable for models with Heating feature only.
7
(3) (1),(2)