Connection; Monitoring; Disconnecting; Troubleshooting - Teac TASCAM DR-05X Mode D'emploi

Connection

1.
Select the type of connected device.
Options: PC/Mac (default), iOS
NOTE
When PC/Mac is selected, the unit with operate on bus
power from the computer.
2.
Set the sampling rate.
Options: 44.1k, 48k (default)
3.
Select Exec at the CONNECT item.
When the unit connects with the external device, the USB
AUDIO I/F screen will open.
12
TASCAM DR-05X

Monitoring

1.
Press the MENU button.
The MENU screen will open.
2.
Selecting the monitored signal.
Options
PC/Mac (default): Monitor the playback sound from the
PC or Mac.
DIRECT: Monitor the input sound without latency.
NOTE
i The meters can be used to check the playback sound of
the external device.
i Sound will not be output from the speaker.
i Use headphones to hear the sound.

Disconnecting

1.
Press the MENU button.
The MENU screen will open.
2.
Select Exec at the DISCONNECT item.
The recorder disconnects from the external device, and the
Home screen opens.

Troubleshooting

If you are having trouble with the operation of this unit,
please try the following before seeking repair. If these
measures do not solve the problem, please contact the store
where you purchased this unit or TASCAM customer support
service.
Power will not turn ON.
i Confirm that batteries are installed correctly.
i Confirm that the HOLD switch is not set.
The unit turns off automatically.
i Check the automatic power saving function setting. Set it
to "Off" to prevent the power from turning off automati-
cally. See "Setting the automatic power saving function" in
"11 − Settings and Information" of the Reference Manual.
The microSD card is not recognized.
i Confirm that the microSD card is inserted completely.
No sound is output or sound is not output from
the speaker.
i Confirm that the output volume is not lowered it too
much.
i Confirm that the speaker setting is on. Even if the speaker
setting is on, sound will not be output from the speaker
when headphones are connected or when the unit is
recording or in recording standby.
Recording is not possible.
i Confirm that the REC indicator is lit. If the REC indicator is
blinking, the unit is in recording standby.
i Check the remaining available recording time shown on
the Recording screen.