Specifications; Design And Function; Transport, Packaging And Storage - WIKA TW10-S Mode D'emploi

Les langues disponibles

2. Safety ... 5. Transport, packaging and storage

2.3 Special hazards

WARNING!

For hazardous media such as oxygen, acetylene, flammable or toxic gases or liquids,

and refrigeration plants, compressors, etc., in addition to all standard regulations, the

appropriate existing codes or regulations must also be followed.

Make sure that the thermowell is sufficiently earthed.

WARNING!

Residual media on dismounted thermowells can result in a risk to persons, the

environment and the equipment. Take sufficient precautionary measures.

3. Specifications

For specifications see the appropriate WIKA data sheets for current thermowell versions and the

order documentation.

4.1 Description

Metal thermowells can be manufactured as solid-machined or fabricated versions. Thermowells

can be connected to the process by screw-, weld- or flange-fitting. The temperature sensor is

directly fastened to the thermowell using a female or male thread or by means of an neck tube.

If thermowells made of metallic materials do not show a sufficient temperature or corrosion

resistance during continuous operation at temperatures above 1,200 °C, ceramic thermowells

should be used.

4.2 Scope of delivery

Cross-check scope of delivery with delivery note.

5.1 Transport

Check thermowell for any damage that may have been caused by transport. Obvious damage

must be reported immediately.

5.2 Packaging

Do not remove packaging until just before mounting.

Keep the packaging as it will provide optimum protection during transport (e.g. change in

installation site, sending for repair).

WIKA operating instructions thermowells

Table des Matières