Maintenance - Greencut JET-2800SX Manuel D'utilisation

1. Assemble the high-pressure hoses, lance and fittings into the required configuration.
2. Attach a nozzle to the end of the lance extension.
3. Connect the high-pressure hose to the pump outlet connector.
4. Connect the machine to the water supply and turn the water supply ON.
5. Squeeze the lance trigger and allow any air in the hoses and pump to be ejected by the water supply
pressure. The water should flow freely before starting the engine.
6. Start the engine.
USING THE LANCE
The lance has a "trigger" (A) to start and stop spraying. The lance may feature a "lock" (B) that prevents the trigger
accidentally being pulled. To spray, release the lock (if fitted or engaged) and pull the trigger – the spray action will
continue while the trigger remains pulled. Release the trigger to stop the spray action.
A

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
MAINTENANCE
Oil level
Oil change
Air filter
Spark plug
Fuel supply pipe
Exhaust valve
Combustion chamber
Idle
Bolts
Fuel tank
Fuel filter
FIRST MONTH
EVERY USE
OR 20H. USE
Check
Check
Check
Check
EVERY 3 EVERY 6
MONTHS OR MONTHS OR
50H. USE 100H. USE
Perform
Replace
Clean or
Replace
Check
Clean or Replace
79
EN
B
EVERY YEAR OR
300H. USE
Clean or
Replace
Replace
Check
Check
Drain and clean